JR Propo NX8931 Programmable WV XBus Servo

JR Propo NX8931 Programmable WV XBus Servo

JR is pleased to announce the release of our new XBus NX series servos, allowing not only serial servo connection, but also individual servo programming with servo adjustments to suit every application.

Highlights :
The NX range of servos automatically detect the type of output they are plugged into - conventional receiver PWM outputs, or XBus. This means NX series servos are XBus compatible, and also compatible with PWM receiver signals without any converter, allowing modelers to use conventional receiver systems.
* Compatible receiver systems : DMSS · DSMJ · 72MHz · 40MHz

When used on a JR XBus system, the NX series servos can be programmed in ways not previously possible. No additional programming device is necessary these servos can be setup using a JR XG series transmitter.

Changes made to servo programming are immediately apparent. Not only can servo direction and travel be adjusted, but it is now possible to fine tune servo gain, dead band and boost to suit your aircraft and desired response. This precise setup allows servo hunting to be eliminated and precise feel maintained.

[Dimensions] 35 x 21 x 40.5mm
[Wire Length] 300mm
[Voltage Range] 4.5V-8.5V
· Metal Gears
· Dual Ball Bearing
· Heatsink Case
· MPU: 32Bit
· Control Frequency:1kHz 《XBus 1kHz/PWM 333Hz
· Neutral: 1500μSec.
2pcs available